Gas Fitter Georgetown

Georgetown Plumbing Co handles gas fitting in Georgetown for cooktops, ovens, heaters, BBQ bayonets, pool heaters, dated connection upgrades and gas leak repairs. Licensed plumbers and gas fitters carry out the work, each line is pressure tested when it is finished, and you agree the cost first. The rest of our work sits on the Georgetown Plumbing Co home page.

Call (02) 4063 1232 Request a quote

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Available 24/7
No call-out fee (excluding after-hours)
Fixed, up-front quotes
365-day warranty on all work

Georgetown Gas Fitting Services

Gas work on this site splits across two dedicated pages:

Gas Appliance Installation

Something new going in. A cooktop, oven, heater, BBQ point or pool heater needs its line run or extended, the appliance connected, and the whole system tested. The appliance installation page covers how a fit-out runs.

Gas Leak Detection and Repair

A smell or a hiss. A suspected leak is traced with gas detectors and repaired on the spot where access allows. The gas leak page puts the safety steps first, including when the gas network needs ringing before we do.

Freestanding gas cooker connected in a kitchen

What Can Go Wrong With Old Gas Fittings?

Dated connections behind renovated kitchens

Cottages this old can hide ageing gas fittings that nobody sees until a kitchen is stripped, and a new cooktop is the moment they come to light.

Corroded or loosened joints

A joint that has sat inside a wall or under a floor for decades can weep slowly, and a faint smell near one fitting is the sign, not anything you can see.

Appliances moved without the line being rerun

A new oven position or a heater shifted to another wall means the pipe has to be extended to reach it properly, not stretched with a longer hose.

Flexible connectors past their service life

Hoses on heaters and cooktops age, and one that has outlasted several owners deserves a check before it fails.

How a Gas Job Runs

1
Ring or send the form
Call (02) 4063 1232 or use the form to explain the fault. We ask enough to bring the right equipment the first time.
2
A fixed price first
A plumber inspects the job and names a fixed figure up front. Nothing gets started until you give the go-ahead.
3
Test, fit, certify
The gas is isolated, the line is tested or run, the appliance goes on, and the finished work is pressure tested and certified.
4
Covered for a year
Every job carries our 365-day warranty on all work. If something we did isn't right, ring the same number.

What Shapes the Cost of Gas Work?

"Not only all of that but the job came in right on quote." Steve

On gas jobs the price starts with how much pipe sits between the meter and the appliance:

The length of new line needed to reach the appliance position
Whether a tired connection or pipe section gets swapped while we have access
The appliance: a single bayonet takes far less work than connecting a flued heater or a pool heater
Night or weekend work, which runs on the after-hours rate we name on the phone

We provide up-front, honest quotes that will always match the final price, should you decide to go ahead. On gas that protects you from the one unknown, the state of pipe hidden inside a wall, because we test it before the number is set.

Gas Work on 1850s Cottage Stock

Cottages first, gas added later

Georgetown grew from the 1850s as housing for families working at the nearby engineering and copper works, and many of those early weatherboard and brick cottages still stand on the compact streets. Gas was piped into them long after they were built, one renovation at a time.

Renovation is when the old work surfaces

Pre-war homes here can keep outdated gas fittings that only appear once a kitchen or heater comes out, and the safe move then is upgrading them while the wall is open, not working around them.

Short runs, tight access

Small lots keep the pipe runs short, which helps, but a cramped subfloor or a connection boxed in behind a renovated wall takes longer to reach, and access is weighed into every quote.

When We're Not the Right Call

The meter, the service pipe to it and the gas main in the street all belong to the gas network, so a fault on any of them goes to their emergency number, and if you can smell gas you get outside before ringing anyone. Downstream of the meter, the pipework and appliances are ours to test and repair.

Gas Fitting Questions From Georgetown Households

Do gas cooktop and heater installs need a licensed gas fitter?

Yes. In NSW, connecting gas pipe or a gas appliance is licensed work, so a fitter makes the connection and certifies it. That applies to a kitchen hob as much as an outdoor heater, and the finished line is pressure tested before the gas is turned back on.

Can an old cottage in Georgetown keep its existing gas line?

It can if the line passes a pressure test. Some pre-war runs behind the walls are still sound and some are not, and the gauge settles which it is. Where a section has to go, it is written into the quote before any wall is opened.

What should I do if I can smell gas inside?

Get everybody out and do not flick switches, pull plugs or use anything that could spark. Once you are well clear, phone the gas distributor's emergency line, then ring us for the repair once they have made the supply safe.

Is a gas bayonet point a big job to add?

It is one of the lighter gas jobs. The new point branches off the closest run of gas pipe and ends at a wall or floor plate, then it is tested before we leave. Distance from that run is what sets the price, and you see it before we start.

Need a plumber? Call or send the form

Call (02) 4063 1232 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4063 1232

Request a callback

Leave a name and number and a plumber will ring you back.